Search results

• Seismic facies analysis
  ...most useful for calibration with lithofacies interpreted from [[Quick-look lithology from logs|well logs]], [[Core description|cores]], and [[Mudlogging: drill # Estimate lithology using depositional setting interpretation from step 6 and all available dat
  6 KB (809 words) - 17:46, 4 February 2022
• Predicting preservation and destruction of accumulations
  | Trapping geometry changes so petroleum spills below the sealing lithology. | Lack of integrity of sealing lithology allows petroleum to leak through the seal.
  5 KB (782 words) - 22:36, 31 January 2022
• Open hole tools
  ...uration. The ''lithology and porosity'' devices are used to determine both lithology and porosity. A variety of ''auxiliary'' tools are used to make special log | rowspan = 3 | Correlation and lithology || Spontaneous potential
  23 KB (3,350 words) - 17:26, 18 January 2022
• Fault seal analysis for reservoir development
  ...eservoir lithology of one fault block is juxtaposed with the non-reservoir lithology of the opposite fault block. ...The trap and spill point can then be determined from the alignment of the lithology units.]]
  14 KB (2,146 words) - 19:35, 13 September 2022
• Mudlogging: drill cuttings analysis
  ...supportive information for subsequent [[show evaluation]], correlation of lithology to wireline logs, and other special geological, geophysical, or engineering ...results in (1) a high percentage of cavings that can mask the true drilled lithology, (2) loss of soluble minerals such as [[gypsum]] and salt and some shales,
  10 KB (1,482 words) - 15:25, 24 January 2022
• Standard interpretation
  ...ty and lithology. (Determination of lithology is discussed in [[Quick-look lithology from logs]].) ...fl</sub> at the depth of interest. The matrix density is determined by the lithology. Normally, sandstone is 2.65 g/cm³, [[limestone]] is 2.71 g/cm<s
  25 KB (3,776 words) - 19:53, 18 January 2022
• Quick-look lithology from logs
  | chapter = Quick-look lithology from logs ! Lithology || Gamma Ray Values (in API units)
  25 KB (3,637 words) - 19:39, 18 January 2022
• Core description
  ===Lithology=== ...val, lithologies should be logged by estimating the percent volume of each lithology and noting the terrigenous clastic lithologies to the left of the chemical
  13 KB (1,786 words) - 20:50, 19 January 2022
• Shale gouge ratio
  ...e fault gouge zone. The gouge ratio reflects the proportion of the sealing lithology in the rock interval that has slipped past a given point on the fault. (a)
  3 KB (473 words) - 20:04, 11 March 2015
• Postaccumulation cementation
  ...reservoir rock may approach that of moderate-quality seals. As a result, a lithology that could seal an accumulation at shallow depth may no longer be effective
  3 KB (430 words) - 15:35, 1 February 2022
• Seismic interpretation
  ...pulse. This information can often be used to support conclusions about the lithology and fluid content of the seismic reflector being evaluated. ...t determining changes in pore fluid, [[porosity]], [[fracture]] intensity, lithology, and so on from [[seismic data]]. Direct hydrocarbon indicators (DHI, HCIs,
  10 KB (1,520 words) - 18:48, 21 January 2022
• Paleogeography and prospect identification
  ...l facies such as [[Fossil assemblage|biofacies]], net reservoir thickness (lithology or [[porosity]]), and [[Seismic facies mapping|seismic facies]] (i.e., [[cl
  4 KB (491 words) - 14:27, 21 March 2022
• Flow units and containers
  ...igure number|3}}Flow unit definition using water saturation, log analysis, lithology, and mean pore throat size (pore size). &copy; Hartmann and Coalson.<ref na ...ado illustrates flow unit definition using water saturation, log analysis, lithology, and mean pore throat size (pore size).
  9 KB (1,231 words) - 18:42, 1 April 2022
• Fault control on hydrocarbon distribution
  Compartment D is commonly empty because a series of juxtaposed lithology leak points (JLLP) along the western portion of Fault A allows hydrocarbons
  4 KB (515 words) - 21:31, 29 March 2022
• Depositional trap regime
  ...tion or lithology. Where described, trap styles can be listed based on the lithology or composition of the sealing rocks. The outline below shows the classes an
  10 KB (1,231 words) - 20:28, 4 January 2024
• Percent fill: controlling factors
  ...(SSP). A [[cross-leaking fault]] limits the percent fill to the juxtaposed lithology leak point (JLLP). A [[dip]]-leaking fault limits the percent fill to the f
  3 KB (471 words) - 21:50, 28 March 2022
• Seal ductility
  | Lithology || Grain mineralogy and cement type control ductility. Brittle seals includ
  4 KB (510 words) - 15:22, 30 March 2022
• Seismic data: analyzing individual reflectors
  ...itude. Analysis within specific reflectors can give us clues to changes in lithology or [[porosity]].
  4 KB (481 words) - 18:20, 4 February 2022
• Geologic mapping (UGM)
  ...formation of the outer layer of earth [[crust]]; they are a variation of [[lithology]], distribution of geologic structure, [[stratigraphy]] and geomorphology. ...elatively homogeneous. While systematic mapping is used when variations of lithology are very complex so observation of some point isn’t enough to represent a
  29 KB (4,733 words) - 15:34, 15 January 2024
• Paleontology
  ...ts|depositional environment]], [http://www.thefreedictionary.com/lithology lithology], and [[Diagenesis|diagenetic events]]. Knowledge of these factors influenc ===Lithology===
  17 KB (2,331 words) - 20:11, 10 August 2016

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)