Difference between revisions of "Cross-sealing fault"
(Initial import) |
(→See also: deleting) |
||
Line 37: | Line 37: | ||
==See also== | ==See also== | ||
* [[Fault seal behavior]] | * [[Fault seal behavior]] | ||
− | |||
* [[Cross-leaking faults]] | * [[Cross-leaking faults]] | ||
* [[Dip-sealing faults]] | * [[Dip-sealing faults]] |
Revision as of 13:58, 31 January 2014
Exploring for Oil and Gas Traps | |
Series | Treatise in Petroleum Geology |
---|---|
Part | Predicting the occurrence of oil and gas traps |
Chapter | Evaluating top and fault seal |
Author | Grant M. Skerlec |
Link | Web page |
Store | AAPG Store |
A cross-sealing fault prevents communication of hydrocarbons between juxtaposed sands (reservoirs). Cross-sealing faults can be identified using the following criteria:
- Hydrocarbon-bearing sands against water-wet sands
- Different hydrocarbon contacts
- Different pressures
Hydrocarbon against water
A fault is cross sealing if it juxtaposes hydrocarbon-bearing sands with water-wet sands, as illustrated in the following figure. Both oil and gas are prevented from flowing into the sand in the hanging wall (Rd) by the cross-sealing fault.
Different hydrocarbon contacts
A fault is also cross sealing if it juxtaposes sands with different hydrocarbon contacts and/or different free water levels, as illustrated in the following figure. Small differences in hydrocarbon contacts do not necessarily imply a cross-sealing fault because the capillary properties of the juxtaposed sands can create different hydrocarbon contacts even across a cross-leaking fault. Different free water levels do imply a cross-sealing fault.
Different pressures
Different pressures across a fault imply cross seal. In the figure below, wells 1 and 2 are separated by a cross-sealing fault. Well 2 encountered virgin pressures in contrast to the lower pressures in the main field.
See also
- Fault seal behavior
- Cross-leaking faults
- Dip-sealing faults
- Dip-leaking faults
- Controls on percent fill