Dip

From AAPG Wiki
Revision as of 19:24, 7 March 2014 by FWhitehurst (talk | contribs)
Jump to navigation Jump to search
Figure 1 Strike and dip of the beds: 1-Strike, 2-Dip, 3-Apparent dip, 4-Angle of dip.

True dip is the angle between an inclined surface and the horizontal, measured perpendicular to a horizontal line in the plane (strike). The dip seen in a limited data set (well bore, outcrop, cross section, seismic line, etc.) may not be perpendicular but rather cut at an angle, and is the apparent dip; this is less that the true dip.it is usually written as 4S (dipping 4 degrees in the southerly option perpendicular to strike; this requires that a strike be given), 4 SE (likewise), or 4 65SE (dipping 4 degrees in a 65SE direction; this by inference gives the strike, because it is perpendicular).

This article is a stub. You can help AAPG Wiki by expanding it.