Tar sands

From AAPG Wiki
Revision as of 14:13, 21 May 2014 by Molyneux (talk | contribs)
Jump to navigation Jump to search
Energy: A Historical Perspective and 21st Century Forecast
Series Studies in Geology
Chapter Sources of Energy
Author Dr. Amos Salvador
Link Web page
PDF PDF file (requires access)

Tar sands (also called bituminous sands and oil sands) have, in general, been defined as reservoirs containing oil too viscous to flow into a well in sufficient quantities for economic production or, in other words, oil essentially immobile in the reservoir. Several more specific definitions have been proposed, but none has been generally accepted. A United Nations Institute for Training and Research (UNITAR) Working Group on Definitions[1][2] stated that, in determining the resource volumes of heavy oil and bitumen, viscosity of the oil should be used first to differentiate between crude oils, on one hand, and bitumens on the other. Density (specific gravity) should be considered next. Tar sands were therefore said to be characterized as containing bitumen, liquids, or semisolids with viscosities greater than 10,000 centipoise (cp) at original reservoir temperature, generally corresponding to a specific gravity of less than 10° API at 60°F (16°C). Carrigy[3] was critical of this definition and preferred to define tar sands as "reservoirs that contain low-gravity oil (~10° API or less) and need a large thermal input to reduce the oil viscosity to a level that will allow it to be produced through a well at economic rates." Other authors have defined tar sands as reservoirs containing oil with a specific gravity of less than 10° API (bitumen) and immobile in the reservoir.

The general term tar sands will be used in this article to include both bitumen and extra-heavy-oil accumulations.

Tar-sand deposits are known from many parts of the world, but present knowledge indicates that two giant deposits, one in western Canada and the other in eastern Venezuela, may contain as much as 80-85% of the approximately 3800 billion bbl of total bitumen and extra-heavy oil in place in the presently known tar-sand deposits. Following the definitions discussed above, the tar sands of western Canada are considered bitumen deposits, while the Orinoco Oil Belt of eastern Venezuela falls into the category of heavy- and extra-heavy-oil accumulation, because although the specific gravity of the oil ranges from 4 to 17° API and averages less than 10° API, the reservoir temperatures are high enough to lower the viscosities to less than 10,000 cp, making the oil mobile under reservoir conditions and allowing some of the oil in place to be recovered by primary production methods; in other words without the need for thermal stimulation.[4]

The only other major tar-sand deposits may be located in the former Soviet Union, but they are poorly understood, because available information concerning their size and characteristics is still ambiguous and inconsistent.

The low commercial value assigned until recently to tar-sand deposits may be responsible for other large bitumen or extra-heavy-oil accumulations having remained undiscovered, unreported, or undeveloped. All important tar-sand deposits may therefore not have been discovered yet.

This situation will no doubt change as concern for the potential exhaustion of conventional lighter oil deposits increases; as technology for extracting and upgrading the bitumen contained in the tar sands to an economical feedstock for refineries becomes available; and as new uses for the bitumen are developed, as, for example, the elaboration in Venezuela of the Orimulsion, a direct combustion product, an emulsion composed of 70% extra-heavy oil suspended in 30% water with the help of a chemical surfactant to stabilize the emulsion.[5]

Although problems of upgrading, transportation, and use need to be solved, the economics of producing bitumens and extra-heavy oils are improving, and attention is progressively being focused in the last few years on delineating and assessing the known bitumen and extra-heavy- and heavy-oil deposits and in searching for new ones. Many of the tar-sand deposits crop out and were identified early in the exploration for oil throughout the world. Most of those that do not crop out are at shallow depths along the rims of sedimentary basins and were discovered when drilling for deeper, lighter oil prospects. Not many of those that crop out have remained unknown, but some of those in the shallow subsurface may be still waiting to be discovered.

See also[edit]

References[edit]

  1. Danyluk, M., B. Galbraith, and R. Omaña, 1984, Toward definitions for heavy crude oil and tar sands, in R. F. Meyer, J. C. Wynn, and J. C. Olson, eds., The future of heavy crude and tar sands: Second International United Nations Institute for Training and Research International Conference (Caracas, Venezuela, February 1982): New York, McGraw Hill, p. 3-6.
  2. Martinez, A. R., 1984, Report on Working Group on Definitions, in R. F. Meyer, J. C. Wynn, and J. C. Olson, eds., The future of heavy crude and tar sands: Second International United Nations Institute for Training and Research International Conference (Caracas, Venezuela, February 1982): New York, McGraw Hill, p. Ixvii-Ixviii.
  3. Carrigy, M. A., 1983, Thermal recovery from tar sands: Journal of Petroleum Technology, v. 35, no. 13, p. 18.
  4. Masters, C. D., D. H. Root, and W. D. Dietzman, 1983, Distribution and quantitative assessment of world crude-oil reserves and resources: U.S. Geological Survey Open-file Report 83-728, 11p.
  5. Pacheco, L. A., and J. Alonso, 1995, Orimulsion-The growing pain of an idea, in R. F. Meyer, ed., Heavy crude and tar sands-Fueling for a clean and safe environment: 6th United Nations Institute for Training and Research International Conference on Heavy Crude and Tar Sands (Houston, Texas, February 1995), v. 1, p. 203-211.

External links[edit]

find literature about
Tar sands
Datapages button.png GeoScienceWorld button.png OnePetro button.png Google button.png