Changes

Numerous interpretation pitfalls, which can make part or all of an interpretation uncertain, are also important to evaluate. Since velocity is affected by many factors, incomplete geological characterizations or log data increase the uncertainty of tomography interpretations. Sufficient well data are therefore necessary to support interpretation adequately. In reservoirs where EOR processes cause rapid changes, correlation of tomograms with older logs may not be valid. Efforts should be made to run logs at the same time the tomography data are acquired.

Numerous interpretation pitfalls, which can make part or all of an interpretation uncertain, are also important to evaluate. Since velocity is affected by many factors, incomplete geological characterizations or log data increase the uncertainty of tomography interpretations. Sufficient well data are therefore necessary to support interpretation adequately. In reservoirs where EOR processes cause rapid changes, correlation of tomograms with older logs may not be valid. Efforts should be made to run logs at the same time the tomography data are acquired.

Tomography display parameters are one of the more important factors governing the ease of interpretation and acceptance of results. To facilitate correlations with cross-borehole geology, tomogram velocity fields should be scaled to match major stratigraphic and reservoir units ([[:file:cross-borehole-tomography-in-development-geology_fig4.jpg|Figure 4]]). The definition of smaller velocity fields may be appropriate to show details such as reservoir heterogeneity within selected major velocity fields. Stratigraphic units such as formation tops and sedimentary facies should also be delineated. In addition to defining velocity fields that match geological units, the use of standard colors and/or graphic symbols for rock units is important. Cold colors (blues) should be used for high velocity fields with a transition to hot colors (reds) for low velocities. Using these guidelines for display should result in tomograms that closely resemble [[geological cross sections]] and are more readily understood and utilized by geologists, engineers, and management. Analysis of tomograms with reference to reservoir models and any available surface seismic should provide the basis for interpretations that can be summarized with integrated data displays, as illustrated in [[:file:cross-borehole-tomography-in-development-geology_fig5.jpg|Figure 5]]. Most important are the well data to velocity field correlations and the log to tomography correlations documenting lithology, porosity, fluid saturation, and temperature. The resulting log and tomography display should provide the data needed to qualitatively document cross-borehole structure, especially dip and faults, reservoir heterogeneity and homogeneity, fluid contacts and any EOR flood fronts.

Tomography display parameters are one of the more important factors governing the ease of interpretation and acceptance of results. To facilitate correlations with cross-borehole geology, tomogram velocity fields should be scaled to match major stratigraphic and reservoir units ([[:file:cross-borehole-tomography-in-development-geology_fig4.jpg|Figure 4]]). The definition of smaller velocity fields may be appropriate to show details such as reservoir heterogeneity within selected major velocity fields. Stratigraphic units such as formation tops and sedimentary facies should also be delineated. In addition to defining velocity fields that match geological units, the use of standard colors and/or graphic symbols for rock units is important. Cold colors (blues) should be used for high velocity fields with a transition to hot colors (reds) for low velocities. Using these guidelines for display should result in tomograms that closely resemble [[geological cross sections]] and are more readily understood and utilized by geologists, engineers, and management. Analysis of tomograms with reference to reservoir models and any available surface seismic should provide the basis for interpretations that can be summarized with integrated data displays, as illustrated in [[:file:cross-borehole-tomography-in-development-geology_fig5.jpg|Figure 5]]. Most important are the well data to velocity field correlations and the log to tomography correlations documenting lithology, porosity, fluid saturation, and temperature. The resulting log and tomography display should provide the data needed to qualitatively document cross-borehole structure, especially [[dip]] and faults, reservoir heterogeneity and homogeneity, fluid contacts and any EOR flood fronts.

==See also==

==See also==

[[Category:Geophysical methods]]

[[Category:Geophysical methods]]