Search results

• Maps of hydrocarbon types: Gulf of Mexico example
  By overlaying maps of total overburden thickness above major source-rock intervals, thermally mature source-rock d
  5 KB (633 words) - 20:02, 18 February 2022
• Shale tectonics
  ...confining stresses of the overburden, sudden mass failure downslope of the overburden, regional compression, or seismicity. ...ty, approximately 0.5 ohm m; and (4) high fluid pressure, about 90% of the overburden pressure. Other authors (Henry et al.<ref name=Henryetal_2010 />) have docu
  17 KB (2,466 words) - 16:16, 10 January 2024
• Micropermeable seal leakage
  .... In both the seal and the reservoir, fluid pressures are less than 75% of overburden stress. This indicates [[Natural hydraulic fracturing of top seals|natural
  5 KB (742 words) - 17:11, 1 February 2022
• East Breaks seal rock
  * [[East Breaks overburden rock]]
  5 KB (662 words) - 14:48, 19 December 2023
• Petroleum system: geographic, stratigraphic, and temporal extent
  ...ered accumulations in the system, whichever is deeper, to the top of the [[overburden]] rock.The stratigraphic extent can be displayed on the burial history char
  7 KB (969 words) - 19:14, 25 January 2022
• Pressure prediction: analysis of cuttings
  ...e rock matrix; this directly affects compaction. Fluid carries some of the overburden stress. When fluid pressure is abnormally high, the intergranular stress is
  5 KB (818 words) - 17:56, 17 February 2022
• Reservoir drive mechanisms
  ...), increases because pore fluid pressure carries less of the weight of the overburden. Some reservoirs respond to the increase in P_nc by the collapse
  7 KB (1,052 words) - 18:45, 1 April 2022
• Petroleum system concept: examples of application
  Linking the elements (source, reservoir, seal, and overburden) to the processes of [[petroleum]] geology (trap formation and hydrocarbon
  7 KB (1,083 words) - 21:59, 25 January 2022
• Stimulation
  ...mes 1000 psi or slightly greater, there is sufficient pressure to lift the overburden. At this point, a horizontal fracture occurs (that is, a fracture perpendic ...omhole pressure of 3500 psi. Since this pressure is inadequate to lift the overburden weight of the earth, it is inferred that the fracture is not horizontal but
  24 KB (3,633 words) - 13:55, 24 January 2022
• Production problems
  ...ressure caused by the overlying rock tends to compress the formation. This overburden pressure can also alter the pore structure and reduce the permeability. The
  16 KB (2,540 words) - 18:41, 20 January 2022
• Making regional structural cross sections
  ...93, Modeling of segmentation and emplacement of salt sheets in anisotropic overburden: Selected Papers, Gulf Coast Section SEPM 13th Annual Research conference,
  7 KB (970 words) - 20:33, 18 February 2022
• Subsurface diagenesis and its relation with diagenetic trap on carbonate rocks reservoir
  Mechanical compaction is resulted from overburden pressure during burial or from tectonics. Compaction causes exaggerated app ...c trap as a result of loss updip porosity. Calcite cementation happened to overburden contact oil / water. (B) With folding contact of oil / water layer is at en
  16 KB (2,395 words) - 21:18, 9 January 2024
• East Breaks source rock
  * [[East Breaks overburden rock]]
  7 KB (1,080 words) - 17:44, 23 March 2022
• Vibro-sesismic to increasing the production rate of coal bed methane
  ...um Stimulasi Vibrasi Terhadap Contoh Batuan Lapangan Pada Berbagai Tekanan Overburden. Department Petroleum Engineering: Institut Teknologi Bandung.</ref>
  11 KB (1,551 words) - 16:49, 11 January 2016
• Fractured reservoir evaluation
  ...tight gas reservoirs|tight gas]] with basin center locations and excessive overburden) || Requires appropriate exploration strategies or reservoir engineering ap ...uses|Underpressured]] formation or reservoir due to stripping (erosion) of overburden || Requires appropriate exploration strategies or reservoir engineering app
  26 KB (3,674 words) - 21:21, 19 January 2022
• Structural exploration: thrust belt example
  ...e. They were [[Deformation|deformed]] in a pressure vessel at an effective overburden pressure of 15 × 10³ psi (1 × 10⁵ kPa). The top vie
  14 KB (1,897 words) - 20:01, 3 February 2022
• Core-to-log transformations and porosity-permeability relationships
  ...ctions may need to be applied to the core data, such as accounting for net overburden conditions.
  14 KB (1,893 words) - 20:15, 2 February 2016
• East Breaks reservoir rock
  * [[East Breaks overburden rock]]
  13 KB (1,771 words) - 17:24, 5 December 2023
• Relationship between porosity and permeability on fractured basement reservoir
  ...roleum reservoar rocks can be found in most of depth, in deeper depth, the overburden pressure is enough to deform sedimentary rock plastically. It cannot hold o
  29 KB (4,601 words) - 16:09, 12 April 2016
• Reservoir engineering
  ...have hydrostatic pressure that associated reservoir system. Pressure from overburden rock also press the pore and increase the fluid pressure.
  14 KB (2,122 words) - 17:33, 7 March 2016

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)