Search results

• Amplitude (seismic)
  ...as strong amplitude with red color amplitude. The change polarity of other lithology to top carbonate commonly from low to high IA, if red reflector is negative
  8 KB (1,291 words) - 15:49, 18 January 2017
• Formation evaluation of naturally fractured reservoirs
  ...er features such as a rough borehole, shales, and changes in [[porosity]], lithology, and tool centralization might produce amplitude drops that have nothing to ...ool is run through an unfractured section of reasonably constant porosity, lithology, borehole rugosity, and tool centralization , the shades of dark and light
  9 KB (1,380 words) - 17:25, 18 January 2022
• Geologic mapping (UB)
  [[File:1.jpg|400px|thumbnail|{{figure number|1|}}Lithology of Outcrop and Field Structure Sketch.<ref name=Zakaria>Zakaria, Zulfiadi. #*# Restrict the lithology in accordance with the lithology contacts on the strike and dip map.
  10 KB (1,547 words) - 14:07, 19 March 2019
• Cased hole tools
  ...alinity are known. The porosity devices are used to estimate porosity when lithology is known. Table 1 lists the types of devices used for these purposes, and T ...the compensated neutron to be used in cased hole to estimate porosity when lithology is known. However, the presence of gas in the formation will cause the comp
  10 KB (1,427 words) - 16:26, 18 January 2022
• Seismic facies analysis
  ...most useful for calibration with lithofacies interpreted from [[Quick-look lithology from logs|well logs]], [[Core description|cores]], and [[Mudlogging: drill # Estimate lithology using depositional setting interpretation from step 6 and all available dat
  6 KB (809 words) - 17:46, 4 February 2022
• User:10112132
  [[File:1.jpg|400px|thumbnail|center|Figure 1 Lithology of Outcrop and Field Structure Sketch. <ref>Zakaria, Zulfiadi. 2011. Manaje ...structures in accordance with the boundary of the strike and dip map. Give lithology colour in accordance with the standards colour and provide explanation too.
  10 KB (1,654 words) - 06:11, 30 June 2015
• User:10112132/Sandbox
  [[File:1.jpg|400px|thumbnail|center|Figure 1 Lithology of Outcrop and Field Structure Sketch]] ...structures in accordance with the boundary of the strike and dip map. Give lithology colour in accordance with the standards colour and provide explanation too.
  10 KB (1,633 words) - 05:38, 30 June 2015
• Predicting preservation and destruction of accumulations
  | Trapping geometry changes so petroleum spills below the sealing lithology. | Lack of integrity of sealing lithology allows petroleum to leak through the seal.
  5 KB (782 words) - 22:36, 31 January 2022
• Open hole tools
  ...uration. The ''lithology and porosity'' devices are used to determine both lithology and porosity. A variety of ''auxiliary'' tools are used to make special log | rowspan = 3 | Correlation and lithology || Spontaneous potential
  23 KB (3,350 words) - 17:26, 18 January 2022
• Fault seal analysis for reservoir development
  ...eservoir lithology of one fault block is juxtaposed with the non-reservoir lithology of the opposite fault block. ...The trap and spill point can then be determined from the alignment of the lithology units.]]
  14 KB (2,146 words) - 19:35, 13 September 2022
• Mudlogging: drill cuttings analysis
  ...supportive information for subsequent [[show evaluation]], correlation of lithology to wireline logs, and other special geological, geophysical, or engineering ...results in (1) a high percentage of cavings that can mask the true drilled lithology, (2) loss of soluble minerals such as [[gypsum]] and salt and some shales,
  10 KB (1,482 words) - 15:25, 24 January 2022
• Standard interpretation
  ...ty and lithology. (Determination of lithology is discussed in [[Quick-look lithology from logs]].) ...fl</sub> at the depth of interest. The matrix density is determined by the lithology. Normally, sandstone is 2.65 g/cm³, [[limestone]] is 2.71 g/cm<s
  25 KB (3,776 words) - 19:53, 18 January 2022
• Quick-look lithology from logs
  | chapter = Quick-look lithology from logs ! Lithology || Gamma Ray Values (in API units)
  25 KB (3,637 words) - 19:39, 18 January 2022
• Core description
  ===Lithology=== ...val, lithologies should be logged by estimating the percent volume of each lithology and noting the terrigenous clastic lithologies to the left of the chemical
  13 KB (1,786 words) - 20:50, 19 January 2022
• Shale gouge ratio
  ...e fault gouge zone. The gouge ratio reflects the proportion of the sealing lithology in the rock interval that has slipped past a given point on the fault. (a)
  3 KB (473 words) - 20:04, 11 March 2015
• Postaccumulation cementation
  ...reservoir rock may approach that of moderate-quality seals. As a result, a lithology that could seal an accumulation at shallow depth may no longer be effective
  3 KB (430 words) - 15:35, 1 February 2022
• Seismic interpretation
  ...pulse. This information can often be used to support conclusions about the lithology and fluid content of the seismic reflector being evaluated. ...t determining changes in pore fluid, [[porosity]], [[fracture]] intensity, lithology, and so on from [[seismic data]]. Direct hydrocarbon indicators (DHI, HCIs,
  10 KB (1,520 words) - 18:48, 21 January 2022
• Paleogeography and prospect identification
  ...l facies such as [[Fossil assemblage|biofacies]], net reservoir thickness (lithology or [[porosity]]), and [[Seismic facies mapping|seismic facies]] (i.e., [[cl
  4 KB (491 words) - 14:27, 21 March 2022
• Flow units and containers
  ...igure number|3}}Flow unit definition using water saturation, log analysis, lithology, and mean pore throat size (pore size). &copy; Hartmann and Coalson.<ref na ...ado illustrates flow unit definition using water saturation, log analysis, lithology, and mean pore throat size (pore size).
  9 KB (1,231 words) - 18:42, 1 April 2022
• Fault control on hydrocarbon distribution
  Compartment D is commonly empty because a series of juxtaposed lithology leak points (JLLP) along the western portion of Fault A allows hydrocarbons
  4 KB (515 words) - 21:31, 29 March 2022

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)