Search results

Jump to navigation Jump to search
  • ...andy beds are present, the water remains in the shale pores. As additional overburden is deposited, the shale then has to sustain all or part of the additional w ...ly to a certain depth, then increases abruptly to almost the weight of the overburden, which it then parallels. In the case of line B, the increase of pressure a
    16 KB (2,450 words) - 21:42, 20 January 2022
  • By overlaying maps of total overburden thickness above major source-rock intervals, thermally mature source-rock d
    5 KB (633 words) - 20:02, 18 February 2022
  • ...confining stresses of the overburden, sudden mass failure downslope of the overburden, regional compression, or seismicity. ...ty, approximately 0.5 ohm m; and (4) high fluid pressure, about 90% of the overburden pressure. Other authors (Henry et al.<ref name=Henryetal_2010 />) have docu
    17 KB (2,466 words) - 16:16, 10 January 2024
  • * Overburden,
    4 KB (584 words) - 21:29, 13 October 2014
  • .... In both the seal and the reservoir, fluid pressures are less than 75% of overburden stress. This indicates [[Natural hydraulic fracturing of top seals|natural
    5 KB (742 words) - 17:11, 1 February 2022
  • * [[East Breaks overburden rock]]
    5 KB (662 words) - 14:48, 19 December 2023
  • ...ered accumulations in the system, whichever is deeper, to the top of the [[overburden]] rock.The stratigraphic extent can be displayed on the burial history char
    7 KB (969 words) - 19:14, 25 January 2022
  • ...e rock matrix; this directly affects compaction. Fluid carries some of the overburden stress. When fluid pressure is abnormally high, the intergranular stress is
    5 KB (818 words) - 17:56, 17 February 2022
  • ...), increases because pore fluid pressure carries less of the weight of the overburden. Some reservoirs respond to the increase in P<sub>nc</sub> by the collapse
    7 KB (1,052 words) - 18:45, 1 April 2022
  • Linking the elements (source, reservoir, seal, and overburden) to the processes of [[petroleum]] geology (trap formation and hydrocarbon
    7 KB (1,083 words) - 21:59, 25 January 2022
  • ...mes 1000 psi or slightly greater, there is sufficient pressure to lift the overburden. At this point, a horizontal fracture occurs (that is, a fracture perpendic ...omhole pressure of 3500 psi. Since this pressure is inadequate to lift the overburden weight of the earth, it is inferred that the fracture is not horizontal but
    24 KB (3,633 words) - 13:55, 24 January 2022
  • ...ressure caused by the overlying rock tends to compress the formation. This overburden pressure can also alter the pore structure and reduce the permeability. The
    16 KB (2,540 words) - 18:41, 20 January 2022
  • ...93, Modeling of segmentation and emplacement of salt sheets in anisotropic overburden: Selected Papers, Gulf Coast Section SEPM 13th Annual Research conference,
    7 KB (970 words) - 20:33, 18 February 2022
  • Mechanical compaction is resulted from overburden pressure during burial or from tectonics. Compaction causes exaggerated app ...c trap as a result of loss updip porosity. Calcite cementation happened to overburden contact oil / water. (B) With folding contact of oil / water layer is at en
    16 KB (2,395 words) - 21:18, 9 January 2024
  • * [[East Breaks overburden rock]]
    7 KB (1,080 words) - 17:44, 23 March 2022
  • ...have hydrostatic pressure that associated reservoir system. Pressure from overburden rock also press the pore and increase the fluid pressure.
    12 KB (1,800 words) - 00:36, 1 July 2015
  • ...um Stimulasi Vibrasi Terhadap Contoh Batuan Lapangan Pada Berbagai Tekanan Overburden. Department Petroleum Engineering: Institut Teknologi Bandung.</ref>
    11 KB (1,551 words) - 16:49, 11 January 2016
  • ...tight gas reservoirs|tight gas]] with basin center locations and excessive overburden) || Requires appropriate exploration strategies or reservoir engineering ap ...uses|Underpressured]] formation or reservoir due to stripping (erosion) of overburden || Requires appropriate exploration strategies or reservoir engineering app
    26 KB (3,674 words) - 21:21, 19 January 2022
  • ...e. They were [[Deformation|deformed]] in a pressure vessel at an effective overburden pressure of 15 × 10<sup>3</sup> psi (1 × 10<sup>5</sup> kPa). The top vie
    14 KB (1,897 words) - 20:01, 3 February 2022
  • ...ctions may need to be applied to the core data, such as accounting for net overburden conditions.
    14 KB (1,893 words) - 20:15, 2 February 2016

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)