Hydrocarbon pressure gradient: plotting
(Redirected from Plotting the hydrocarbon pressure gradient)
Jump to navigation
Jump to search
Exploring for Oil and Gas Traps | |
Series | Treatise in Petroleum Geology |
---|---|
Part | Critical elements of the petroleum system |
Chapter | Formation fluid pressure and its application |
Author | Edward A. Beaumont, Forrest Fiedler |
Link | Web page |
Store | AAPG Store |
We can estimate the downdip free-water level from a valid fluid pressure measured within a reservoir.
Plotting gradient
The list below outlines the procedure for plotting a hydrocarbon pressure gradient on a hydrostatic pressure plot when a measured pressure is available from the reservoir.
- Plot measured fluid pressure on a hydrostatic pressure–depth plot.
- Determine the hydrocarbon pressure gradient from one of two ways:
- Measured hydrocarbon density
- Estimates of hydrocarbon density
- Determine the buoyancy pressure gradient: static water pressure gradient minus hydrocarbon pressure gradient.
- Determine a pressure above or below the measured depth point. The table below lists the steps for determining this number.
- Pick a depth above or below the measured point.
- Multiply the difference in depth by the buoyancy pressure gradient.
- Add the number from step 2 to the measured pressure if the depth is deeper; subtract if shallower.
- Example: Measured pressure at depth::7607 ft is pressure::3530 psi and buoyancy pressure gradient is 0.076 psi/ft. What is the hydrocarbon pressure at depth::7507 ft?
- Solution:
- Plot the pressure number from step 4 on the pressure–depth plot and draw a line between this point and the measured pressure point. This line is the hydrocarbon pressure gradient.
See also
- Static hydrocarbon pressure gradients
- Estimating static oil pressure gradients
- Estimating static gas pressure gradients
- Free water level determination using pressure