Changes

Jump to navigation Jump to search
no edit summary
Line 271: Line 271:  
Reservoir zones in the Troll West accumulation are defined by alternating layers of fine-grained, micaceous sandstone and coarse-grained sandstone (informally referred to as m sands and c sands, respectively). The coarse-grained sandstones have higher porosity and permeability (hundreds to thousands of millidarcys) than the fine-grained, micaceous sandstones (tens to hundreds of millidarcys).<ref name=Gbbns /><ref name=Dryr2005 /> Each couplet of fine-grained, micaceous sandstone and overlying coarse-grained sandstones corresponds to the lower and upper part of a single delta-front parasequence.<ref name=Dryr2005 /> The 3-D seismic data image laterally extensive (up to 30 km [19 mi] along depositional strike), near-linear, north-northeast–south-southwest-trending clinoforms that dip west-northwestward at 1.5°–4°.<ref name=Dryr2005 /><ref name=Ptrno /> The structure of the Troll West reservoir is defined by two rotated fault blocks that formed after reservoir deposition, and the reservoir is further segmented by smaller postdepositional faults that trend west-northwest–east-southeast to north-northwest–south-southeast<ref name=Dryr2005 /> ([[:File:BLTN13190fig12.jpg|Figure 12B]]).
 
Reservoir zones in the Troll West accumulation are defined by alternating layers of fine-grained, micaceous sandstone and coarse-grained sandstone (informally referred to as m sands and c sands, respectively). The coarse-grained sandstones have higher porosity and permeability (hundreds to thousands of millidarcys) than the fine-grained, micaceous sandstones (tens to hundreds of millidarcys).<ref name=Gbbns /><ref name=Dryr2005 /> Each couplet of fine-grained, micaceous sandstone and overlying coarse-grained sandstones corresponds to the lower and upper part of a single delta-front parasequence.<ref name=Dryr2005 /> The 3-D seismic data image laterally extensive (up to 30 km [19 mi] along depositional strike), near-linear, north-northeast–south-southwest-trending clinoforms that dip west-northwestward at 1.5°–4°.<ref name=Dryr2005 /><ref name=Ptrno /> The structure of the Troll West reservoir is defined by two rotated fault blocks that formed after reservoir deposition, and the reservoir is further segmented by smaller postdepositional faults that trend west-northwest–east-southeast to north-northwest–south-southeast<ref name=Dryr2005 /> ([[:File:BLTN13190fig12.jpg|Figure 12B]]).
   −
Troll West contains a thin oil column (11–26 m [36–85 ft]) that is exploited through the use of horizontal wells,<ref name=Dryr2005 /> the productivity of which is sensitive to the ratio of vertical-to-horizontal permeability (cf. Joshi<ref>Joshi, S. D., 1987, A review of horizontal well and drain hole technology: SPE Paper 16868, 17 p.</ref>). This ratio is predicted to be influenced by the calcite-cemented concretionary beds that are abundant in the Sognefjord Formation.<ref>Kantorowicz, J. D., I. D. Bryant, and J. M. Dawans, 1987, Controls on the geometry and distribution of carbonate cements in Jurassic sandstones: Bridport Sands, southern England and Viking Group, Troll Field, Norway, inJ. D. Marshall, ed., Diagenesis of sedimentary sequences: Geological Society, London, Special Publication 36, p. 103–118.</ref><ref>Lien, S. C., H. H. Haldorsen, and M. Manner, 1992, Horizontal wells: Still appealing in formations with discontinuous vertical permeability barriers?: Journal of Petroleum Technology, v. 44, no. 12, p. 1364–1370, doi: 10.2118/20962-PA.</ref><ref>Evensen, J. E., M. Skaug, and P. Goodyear, 1993, Production geological challenges of characterizing the thin oil rims in the Troll Field: OTC Paper 7172, Proceedings from the Offshore Technology Conference, Houston, Texas, USA, May 3–6, 1993, 12 p.</ref> These are present within delta-front parasequences, which are seismically imaged as clinoform sets, and along their bounding flooding surfaces.<ref name=Gbbns /><ref>Bakke, N. E., E. T. Ertresvåg, A. Næss, A. C. MacDonald, and L. M. Fält, 1996, Application of seismic data and sequence stratigraphy for constraining a stochastic model of calcite cementation: SPE Paper 35487, 13 p.</ref><ref name=Dryr2005 /><ref>Holgate, N. E., G. J. Hampson, C. A.-L. Jackson, and S. A. Petersen, 2014, [http://archives.datapages.com/data/bulletns/2014/12dec/BLTN13152/BLTN13152.html Constraining uncertainty in interpretation of seismically imaged clinoforms in deltaic reservoirs, Troll Field, Norwegian North Sea: Insights from forward seismic models of outcrop analogs]: AAPG Bulletin, v. 98, no. 12, p. 2629–2663, doi: 10.1306/05281413152.</ref><ref name=Ptrno /> The Jurassic Bridport Sand Formation, a close sedimentologic analog present onshore United Kingdom, contains similarly abundant calcite-cemented concretionary beds. These are observed at the outcrop to be laterally extensive (>80% areal coverage) along bedding planes and in a producing subsurface reservoir; their presence is marked by breaks in pressure and fluid saturation within seismically imaged clinoform sets.<ref>Hampson, G. J., J. E. Morris, and H. D. Johnson, 2014, Synthesis of time-stratigraphic relationships and their impact on hydrocarbon reservoir distribution and performance, Bridport Sand Formation, Wessex Basin, UK, inD. G. Smith, R. J. Bailey, P. M. Burgess, and A. J. Fraser, eds., Strata and time: Probing the gaps in our understanding: Geological Society, London, Special Publication 404, first published online on March 19, 2014, doi: 10.1144/SP404.2.</ref><ref>Morris, J. E., G. J. Hampson, and H. D. Johnson, 2006, A sequence stratigraphic model for an intensely bioturbated shallow-marine sandstone: The Bridport Sand Formation, Wessex basin, UK: Sedimentology, v. 53, no. 6, p. 1229–1263, doi: 10.1111/j.1365-3091.2006.00811.x.</ref> Thus it appears probable that permeability barriers and baffles in the form of calcite-cemented concretionary layers occur along clinoforms in the Troll Field reservoir and could influence drainage patterns and recovery from the thin oil zone;<ref name=Gbbns /> this may have been recognized previously and shown to impact on well test interpretations.<ref>Lien, S. C., K. Seines, S. O. Havig, and T. Kydland, 1991, The first long-term horizontal-well test in the Troll thin oil zone: Journal of Petroleum Technology, v. 43, no. 8, p. 914–973, doi: 10.2118/20715-PA.</ref><ref>Haug, B. T., 1992, The second long-term horizontal well test in Troll: Successful production from a 13-in. oil column with the well partly completed in the water zone: SPE Paper 24943, 10 p.</ref> However, to date, the heterogeneity associated with clinoforms has not been explicitly included in reservoir or flow-simulation models of the Sognefjord Formation in the Troll Field. Dilib et al.<ref name=Dlb>Dilib, F. A., M. D. Jackson, A. Mojaddam Zadeh, R. Aasheim, K. Årland, A. J. Gyllensten, and S. M. Erlandsen, 2015, Closed-loop feedback control in intelligent wells: Application to a heterogeneous, thin oil-rim reservoir in the North Sea: SPE Reservoir Evaluation and Engineering, v. 18, no. 1, 15 p., doi: 10.2118/159550-PA.</ref> created a sector model of the Sognefjord Formation (dimensions: 3200 × 750 × 150 m [10,499 × 2461 × 492 ft]) to investigate production optimization using intelligent wells for a range of uncertainty in geologic parameters and their model, extracted and refined from the existing full field geological model, was used here as the context in which to apply the clinoform-modeling algorithm.
+
Troll West contains a thin oil column (11–26 m [36–85 ft]) that is exploited through the use of [[horizontal well]]s,<ref name=Dryr2005 /> the productivity of which is sensitive to the ratio of vertical-to-horizontal permeability (cf. Joshi<ref>Joshi, S. D., 1987, A review of horizontal well and drain hole technology: SPE Paper 16868, 17 p.</ref>). This ratio is predicted to be influenced by the calcite-cemented concretionary beds that are abundant in the Sognefjord Formation.<ref>Kantorowicz, J. D., I. D. Bryant, and J. M. Dawans, 1987, Controls on the geometry and distribution of carbonate cements in Jurassic sandstones: Bridport Sands, southern England and Viking Group, Troll Field, Norway, inJ. D. Marshall, ed., Diagenesis of sedimentary sequences: Geological Society, London, Special Publication 36, p. 103–118.</ref><ref>Lien, S. C., H. H. Haldorsen, and M. Manner, 1992, Horizontal wells: Still appealing in formations with discontinuous vertical permeability barriers?: Journal of Petroleum Technology, v. 44, no. 12, p. 1364–1370, doi: 10.2118/20962-PA.</ref><ref>Evensen, J. E., M. Skaug, and P. Goodyear, 1993, Production geological challenges of characterizing the thin oil rims in the Troll Field: OTC Paper 7172, Proceedings from the Offshore Technology Conference, Houston, Texas, USA, May 3–6, 1993, 12 p.</ref> These are present within delta-front parasequences, which are seismically imaged as clinoform sets, and along their bounding flooding surfaces.<ref name=Gbbns /><ref>Bakke, N. E., E. T. Ertresvåg, A. Næss, A. C. MacDonald, and L. M. Fält, 1996, Application of seismic data and sequence stratigraphy for constraining a stochastic model of calcite cementation: SPE Paper 35487, 13 p.</ref><ref name=Dryr2005 /><ref>Holgate, N. E., G. J. Hampson, C. A.-L. Jackson, and S. A. Petersen, 2014, [http://archives.datapages.com/data/bulletns/2014/12dec/BLTN13152/BLTN13152.html Constraining uncertainty in interpretation of seismically imaged clinoforms in deltaic reservoirs, Troll Field, Norwegian North Sea: Insights from forward seismic models of outcrop analogs]: AAPG Bulletin, v. 98, no. 12, p. 2629–2663, doi: 10.1306/05281413152.</ref><ref name=Ptrno /> The Jurassic Bridport Sand Formation, a close sedimentologic analog present onshore United Kingdom, contains similarly abundant calcite-cemented concretionary beds. These are observed at the outcrop to be laterally extensive (>80% areal coverage) along bedding planes and in a producing subsurface reservoir; their presence is marked by breaks in pressure and fluid saturation within seismically imaged clinoform sets.<ref>Hampson, G. J., J. E. Morris, and H. D. Johnson, 2014, Synthesis of time-stratigraphic relationships and their impact on hydrocarbon reservoir distribution and performance, Bridport Sand Formation, Wessex Basin, UK, inD. G. Smith, R. J. Bailey, P. M. Burgess, and A. J. Fraser, eds., Strata and time: Probing the gaps in our understanding: Geological Society, London, Special Publication 404, first published online on March 19, 2014, doi: 10.1144/SP404.2.</ref><ref>Morris, J. E., G. J. Hampson, and H. D. Johnson, 2006, A sequence stratigraphic model for an intensely bioturbated shallow-marine sandstone: The Bridport Sand Formation, Wessex basin, UK: Sedimentology, v. 53, no. 6, p. 1229–1263, doi: 10.1111/j.1365-3091.2006.00811.x.</ref> Thus it appears probable that permeability barriers and baffles in the form of calcite-cemented concretionary layers occur along clinoforms in the Troll Field reservoir and could influence drainage patterns and recovery from the thin oil zone;<ref name=Gbbns /> this may have been recognized previously and shown to impact on well test interpretations.<ref>Lien, S. C., K. Seines, S. O. Havig, and T. Kydland, 1991, The first long-term horizontal-well test in the Troll thin oil zone: Journal of Petroleum Technology, v. 43, no. 8, p. 914–973, doi: 10.2118/20715-PA.</ref><ref>Haug, B. T., 1992, The second long-term horizontal well test in Troll: Successful production from a 13-in. oil column with the well partly completed in the water zone: SPE Paper 24943, 10 p.</ref> However, to date, the heterogeneity associated with clinoforms has not been explicitly included in reservoir or flow-simulation models of the Sognefjord Formation in the Troll Field. Dilib et al.<ref name=Dlb>Dilib, F. A., M. D. Jackson, A. Mojaddam Zadeh, R. Aasheim, K. Årland, A. J. Gyllensten, and S. M. Erlandsen, 2015, Closed-loop feedback control in intelligent wells: Application to a heterogeneous, thin oil-rim reservoir in the North Sea: SPE Reservoir Evaluation and Engineering, v. 18, no. 1, 15 p., doi: 10.2118/159550-PA.</ref> created a sector model of the Sognefjord Formation (dimensions: 3200 × 750 × 150 m [10,499 × 2461 × 492 ft]) to investigate production optimization using intelligent wells for a range of uncertainty in geologic parameters and their model, extracted and refined from the existing full field geological model, was used here as the context in which to apply the clinoform-modeling algorithm.
    
===Model Construction===
 
===Model Construction===

Navigation menu