Hydrocarbon pressure gradient: plotting
Revision as of 20:46, 3 June 2014 by FWhitehurst (talk | contribs)
We can estimate the downdip free-water level from a valid fluid pressure measured within a reservoir.
Plotting gradient
The table below outlines the procedure for plotting a hydrocarbon pressure gradient on a hydrostatic pressure plot when a measured pressure is available from the reservoir.
Step | Action |
---|---|
1 | Plot measured fluid pressure on a hydrostatic pressure–depth plot. |
2 | Determine the hydrocarbon pressure gradient from one of two ways:
|
3 | Determine the buoyancy pressure gradient: static water pressure gradient minus hydrocarbon pressure gradient. |
4 | Determine a pressure above or below the measured depth point. The table below lists the steps for determining this number.
Example: Measured pressure at depth::7607 ft is pressure::3530 psi and buoyancy pressure gradient is 0.076 psi/ft. What is the hydrocarbon pressure at depth::7507 ft? Solution:
|
5 | Plot the pressure number from step 4 on the pressure–depth plot and draw a line between this point and the measured pressure point. This line is the hydrocarbon pressure gradient. |