Hydrocarbon pressure gradient: plotting

We can estimate the downdip free-water level from a valid fluid pressure measured within a reservoir.

Plotting gradient

The table below outlines the procedure for plotting a hydrocarbon pressure gradient on a hydrostatic pressure plot when a measured pressure is available from the reservoir.

Step	Action
1	Plot measured fluid pressure on a hydrostatic pressure–depth plot.
2	Determine the hydrocarbon pressure gradient from one of two ways: Measured hydrocarbon density Estimates of hydrocarbon density
3	Determine the buoyancy pressure gradient: static water pressure gradient minus hydrocarbon pressure gradient.
4	Determine a pressure above or below the measured depth point. The table below lists the steps for determining this number. Pick a depth above or below the measured point. Multiply the difference in depth by the buoyancy pressure gradient. Add the number from step 2 to the measured pressure if the depth is deeper; subtract if shallower. Example: Measured pressure at depth::7607 ft is pressure::3530 psi and buoyancy pressure gradient is 0.076 psi/ft. What is the hydrocarbon pressure at depth::7507 ft? Solution: 7607 ft – 7507 ft = 100 ft 100 ft × 0.076 psi/ft = 7.6 psi Hydrocarbon pressure at depth::7507 ft = pressure::3530 psi – pressure::7.6 psi = pressure::3522.4 psi
5	Plot the pressure number from step 4 on the pressure–depth plot and draw a line between this point and the measured pressure point. This line is the hydrocarbon pressure gradient.

See also

• Static hydrocarbon pressure gradients
• Estimating static oil pressure gradients
• Estimating static gas pressure gradients
• Free water level determination using pressure

External links

find literature about Hydrocarbon pressure gradient: plotting

• Original content in Datapages
• Find the book in the AAPG Store