Rock-Eval pyrolysis

What is pyrolysis?

Pyrolysis is the decomposition of organic matter by heating in the absence of oxygen. Organic geochemists use pyrolysis to measure richness and maturity of potential source rocks. In a pyrolysis analysis, the organic content is pyrolyzed in the absence of oxygen, then combusted. The amount of hydrocarbons and carbon dioxide released is measured. The most widely used pyrolysis technique is Rock-Eval.

Rock-eval pyrolysis

Figure 1 Cycle of analysis and the corresponding recording. From Tissot and Weite.^[1] Courtesy Springer-Verlag.

In Rock-Eval pyrolysis, a sample is placed in a vessel and is progressively heated to temperature::550°C under an inert atmosphere. During the analysis, the hydrocarbons already present in the sample are volatized at a moderate temperature. The amount of hydrocarbons are measured and recorded as a peak known as S1. Next pyrolyzed is the kerogen present in the sample, which generates hydrocarbons and hydrocarbon-like compounds (recorded as the S2 peak), CO₂, and water.^[1] The CO₂ generated is recorded as the S3 peak. Residual carbon is also measured and is recorded as S4.

Figure 1 shows the cycle of analysis and the corresponding recording.

Pyrolysis indices

The table below lists the Rock-Eval pyrolysis peaks and explains what they represent.

Peak	Is a measurement of…	Comment
S1 mg Hc/g rock	The free hydrocarbons present in the sample before the analysis	Can be thought of as a residual hydrocarbon phase. When S1 is large relative to S2, an alternative source such as migrated hydrocarbons or contamination should be suspected
S2 mg Hc/g rock	The volume of hydrocarbons that formed during thermal pyrolysis of the sample	Used to estimate the remaining hydrocarbon generating potential of the sample
S3 mg Co2/g rock	The CO₂ yield during thermal breakdown of kerogen	Most prevalent in calcareous source rocks.
S4 mg carbon/g rock	The residual carbon content of the sample	Residual carbon content of sample has little or no potential to generate hydrocarbons due to a lack of hydrogen and the chemical structure of the molecule

Estimating total organic carbon with pyrolysis

The percent total organic carbon (TOC) is actually a value that is calculated, not measured directly, using the following formula:

\%{\mbox{TOC}}=[0.082({\mbox{S1}}+{\mbox{S2}})+{\mbox{S4}}]/10

Units are usually given as wt % organic carbon per weight of dry rock (milligrams hydrocarbon per gram of rock).

References

↑ ^1.0 ^1.1 Tissot, B., P., Welte, D., H., 1984, Petroleum Formation and Occurrence, 2 ed.: New York, Springer-Verlag, 699 p. A good overall reference for petroleum geochemistry.

External links

find literature about
Rock-Eval pyrolysis

[ch06r12-1] 1.0 ^1.1 Tissot, B., P., Welte, D., H., 1984, Petroleum Formation and Occurrence, 2 ed.: New York, Springer-Verlag, 699 p. A good overall reference for petroleum geochemistry.

[1]

Rock-Eval pyrolysis

Contents

What is pyrolysis?