Migration by solution in water

From AAPG Wiki
Revision as of 15:16, 14 February 2022 by Cwhitehurst (talk | contribs) (added Category:Treatise Handbook 3 using HotCat)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
Exploring for Oil and Gas Traps
Series Treatise in Petroleum Geology
Part Critical elements of the petroleum system
Chapter Migration of petroleum
Author Martin D. Matthews
Link Web page
Store AAPG Store

Hydrocarbons dissolved in water occur as true solution and micellar solution. Both of these forms enable the hydrocarbons to move one molecule at a time and thus restrict movement minimally. The method of transport is either through direct transport by the water or by diffusion through the water. Reservoirs formed by this type of migration are limited to gas and light condensates. Solution transport is responsible for the loss of gas from many reservoirs and water-washing of oils.

True solution

Figure 1 The aqueous solubility of normal alkanes and aromatics at 25°C. After McAuliffe.[1]

True solution is a function of pressure, temperature, salinity, molecular weight, and mixtures of components present. The aqueous solubility of normal alkanes and aromatics at temperature::25°C is shown in Figure 1.

Composition of hydrocarbons moved by water

Reservoirs formed by true solution migration are limited to gas and light condensates. This compositional relationship differs significantly from that found in most reservoired oils. However, a few light oils have molecular abundances in agreement with solubility ratios. The occurrence of these light oils as a separate phase demonstrates that solution transport of oils does occur. The infrequent occurrence (less than 10 reported cases) of oils with a compositional signature consistent with solution solubilities suggests this process of migration is an exception rather than the rule.

Exsolution of dissolved hydrocarbons

The movement of water from one location to another transports the associated dissolved gas and oil. As the water mass moves into lower temperature and pressure conditions or its salinity increases, the hydrocarbons exsolve and form a free phase. This should be a relatively continuous process, forming a cloud of bubbles throughout the carrier bed system. A free-phase transport mechanism is then needed to accumulate these bubbles within a reservoir.

Migration by diffusion

migration by diffusion of light hydrocarbons in a water-filled pore system is extremely slow. Diffusion conveys hydrocarbons from areas of high concentrations to areas of lower concentrations. It is dominantly a dispersive force and is generally responsible for the loss of hydrocarbons, not their accumulation.

Diffusion time vs. distance

Figure 2 The time it takes a light hydrocarbon to diffuse a given distance and reach a concentration level equal to half the concentration of a nondepleted source. Copyright: Krooss;[2] courtesy Institute Français du Petrole.

The time it takes a light hydrocarbon to diffuse a given distance and reach a concentration level equal to half the concentration of a nondepleted source is shown in Figure 2.

Diffusion in shale vs. Sand

In sampled beds, dissolved benzene and toluene can follow a diffusion gradient horizontally for miles in sands but be absent vertically in the over- and underlying sections. This observation suggests diffusion is not a practical transport mechanism in shale. However, even in sands for distances greater than 10-100 m, migration by diffusion is insignificant relative to bulk flow of oil or gas as separate phases.

Selective depletion by diffusion

Studies of source and reservoir contacts show that diffusion of dissolved hydrocarbons selectively depletes the more soluble compounds from the edges of [[source rocks]] into adjacent sands. The extracts found in sands resemble condensates or light oils, while the extracts found on the edges of depleted source rocks look less mature and somewhat biodegraded compared to the less depleted center of the source rocks. Diffusion selectively depletes the more soluble compounds in reservoirs. Although light hydrocarbons are expected to be transported only tens of meters into a shale capping a reservoir, significant quantities of light hydrocarbons can diffuse into this section of overlying seal.

Micelles

Micellar solution increases the capacity of water to carry molecular hydrocarbon species by the use of naturally occurring hydrocarbon solubilizers called micelles. Micelles are roughly the size of median shale pores and therefore are only able to travel through the largest shale pore throats without being subject to capillary forces. Natural micelles generally are not present in sufficient concentration to significantly alter the ability of water to contain dissolved hydrocarbons. A major problem with micelles as a transport mechanism is the difficulty of separating the hydrocarbons from them to form an accumulation in a reservoir.

See also

References

  1. McAuliffe, C. D., 1980, Oil and gas migration: chemical and physical constraints, in W. H. Roberts, and R. J. Cordell, eds., AAPG Studies in Geology no. 10, p. 89–107.
  2. Krooss, B. M., 1987, Experimental investigation of the diffusion of low-molicular weight hydrocarbons in sedimentary rocks, in B. Doligez, ed., Migration of Hydrocarbons in Sedimentary Basins: 2nd IFP Expl. Res. Conference Proceedings, p. 329–351.

External links

find literature about
Migration by solution in water
Datapages button.png GeoScienceWorld button.png OnePetro button.png Google button.png