Hydrocarbon expulsion, migration, and accumulation

Exploring for Oil and Gas Traps
Series	Treatise in Petroleum Geology
Part	Predicting the occurrence of oil and gas traps
Chapter	Predicting reservoir system quality and performance
Author	Dan J. Hartmann, Edward A. Beaumont
Link	Web page
Store	AAPG Store

The pores and fluids of a reservoir system interact during the processes of expulsion, migration, accumulation, and flow to a wellbore. Differential pressure (ΔP) in the fluid continuum of the petroleum system, caused by properties of fluids and pores, controls these processes.

Expulsion

Expulsion describes the movement of hydrocarbons from the petroleum source rock into the carrier bed or migration conduit. The expulsion event is driven by a combination of factors that include compaction, chemical reactions, source richness, kerogen type, and thermal expansion. Hydrocarbon generation causes pressure build-up in the source rock, exceeding the pore pressure of the adjacent carrier bed. Oil or gas is expelled or “squeezed” into the carrier bed due to the differential pressures between source rock and fluid in the carrier bed.

Migration

Figure 1 Relationship between the buoyancy pressure (P_b) and the capillary resistance of the water. After Berg.

Hydrocarbon migrates through an aquifer when it is “buoyed” upward due to AP caused by the density differential of the hydrocarbons and the formation water. The oil or gas migrates in filaments through the pore system of the aquifer as long as the buoyancy pressure (P_b) exceeds the capillary resistance of the water in the pore throats. This relationship is illustrated in Figure 1.

For migration to continue as pore throat size decreases from one site to the next (points A and B in Figure 1), the length of the filament (h) must increase until an adequate P_b exists across the pore throat to initiate breakthrough.

Accumulation

A hydrocarbon accumulation forms when migrating hydrocarbon filaments encounter a zone (the seal), either laterally or vertically, with pore throat sizes smaller than the carrier bed. The seal pore throat breakthrough pressure or the distance to the spill point of the trap, whichever is less, determines the hydrocarbon accumulation column height.

Buoyancy pressure profile

Figure 2 Relationship between the hydrocarbon gradient and water gradient. From Coalson et al. Courtesy RMAG.

When a reservoir has formed in a trap and has come to pressure equilibrium with the water in the aquifer, the pore pressure of the hydrocarbons at different depths in the reservoir plot along a steeper gradient than the water gradient. Figure 2 shows this relationship.

The pressure contrast between the hydrocarbon gradient and the water gradient at a given depth in the reservoir (height above free water) is the buoyancy pressure (P_b). The longer the column, the higher the P_b at the top of the column.

Water saturation

The water remaining on the surfaces of the pores and pore throats of a rock after hydrocarbon has driven (drained) out the rest of the water is called the residual water saturation (S_wr). P_b provides the energy needed to overcome the capillary resistance of the water in the pore throat and drive down S_wr in the pore. The higher a portion of the reservoir (with a given capillary pressure profile-pore type) occurs above the zero pressure::(0 psi) P_b position, the lower its S_wr will become. Consequently, an S_wr model can be developed from capillary pressure profiles because S_wr is a function of the profile of pore throat sizes and height above P_b = pressure::0 psi.

See also

• Pore-fluid interaction
• Characterizing rock quality
• Pc curves and saturation profiles
• Converting Pc curves to buoyancy, height, and pore throat radius
• What is permeability?
• Relative permeability and pore type

External links

find literature about Hydrocarbon expulsion, migration, and accumulation

• Original content in Datapages
• Find the book in the AAPG Store